Updated 2005-01-21 : Added some pictures First version 2005-01-19
Warning this modification could shorten the lif of your dreamcast.
I tried to set my dreamcast up to be able to read cdrw using some tutorials on the Internet, but it wouldn't work, in fact the 450 ohms resistor I used was too low (300 Ohms in parallel), I hooked up a trimmer in parallel with the optical unit's trimmer and made some tests (the values I give are for parallel resistors) : 530 ohms : CDR works CDRW does not 507 ohms : CDR works CDRW does not 475 ohms : CDR seems to start having trouble reading CDRW works ! 430 ohms : CDR makes ugly sounds CDRW works 395 ohms : CDR more noise still works CDRW works 342 ohms : CDR does not work CDRW works 320 ohms : neither work.
I tried two different brands of CDRW, both worked (but I made all the tests with only one). I had to use a boot disc, autoselfboot CDRW never worked.
So I must use a resistor in between 475 and 342 ohms, that's for parallel value, as the optical unit's trimmer is set to about 900ohms it gives me 1005ohms and 550ohms for extreme limits. If you want to try by yourself make some experimentations with a 10K trimmer.
Warning it may be dangerous for the laser diode to use values too low, don't go under 200 ohms in parallel.
Here's how I soldered my wires :
First you'll have to open your dreamcast, I assume you're able to do so (and you can solder without messing the components around). Remove the optical unit, only 3 screws and here you go. Open the optical unit, there's 5 screws, two of them are hidden under the black pad (where I put red dots on the image below) if you manage to make the solders without disconnecting the wires, fine, because they're hard to reconnect.
You have to solder two wires to the two leftmost pins of the ribbon cable connector (in fact those two pins lead directly to the two pins of the optical unit trimmer on which other cdrw tutorials said to solder wires)
Beware not to melt the ribbon if soldering like this.
A good place for the wires through the shield is the hole for the screw (see picture 1 too)
Then close the optical unit
Solder a resistor (or a trimmer for testing) and a switch at the end of the wires
Make a hole in the dreamcast body and here you are.
Of course I don't take responsability if you burn anything trying to follow this tutorial, this come with hope that it can be useful, but without any warranty.
怎么是这个标题？ 530 ohms : CDR works CDRW does not V瘧 ? 黫 507 ohms : CDR works CDRW does not 旈Z摨?獧? 475 ohms : CDR seems to start having trouble reading CDRW works ! 灅蜸?f? 430 ohms : CDR makes ugly sounds CDRW works JI?? 395 ohms : CDR more noise still works CDRW works 呤?rsM 342 ohms : CDR does not work CDRW works ┕I*N?? 320 ohms : neither work. 褴 这些数据真的准确么？毕竟每台机器状况都不相同。 我不希望自己DC早点挂掉，还是不做这无聊的试验了。
真的能行吗?那样不用刻盘了.$_$